Issue 46

H. Mekri et alii, Frattura ed Integrità Strutturale, 46 (2018) 62-72; DOI: 10.3221/IGF-ESIS.46.07 62 Influence of the coupling between the mechanical characteristics and the welding conditions by the FSSW process: case of the bi-material aluminum-steel H. Mekri, B. Bouchouicha, A. Miloudi University of DjillaliLiabes, SidiBelAbbès, Algeria. mekrihichem@hotmail.fr, b enattou_b@yahoo.fr, miloudidz@yahoo.fr H. Christophe, A. Imad University of Lille 1, France christophe.herbelot@polytech-lille.fr , abdellatif.imad@polytech-lille.fr I NTRODUCTION he increasing demand for energy saving as well as environmental issues in different industry sectors has led to the necessity of using lightweight alloys and advanced high strength steels. Such interest has created the need to develop reliable joining technologies which can enable multilateral design and low cost fabrication processes [1, 2]. The assembly between two different materials (Al/Steel, Al/Cu,…) by conventional technologies of welding by fusion is rather complicated and can be due completely difficult to their various physical and chemical properties, in particular with the difference in the cast iron temperatures and with mutual solubility. Furthermore, these processes have the disadvantage of severe heating and cooling cycles which can result in the formation of brittle cast structure, porosity and large amounts of intermetallic phases (Fe n Al m ) that have a detrimental effect on the mechanical properties of the joint, multiaxial fatigue, fatigue properties and fracture mechanism of load [16, 17, 29, 30]. Brazing has also been used as a tentative process to join aluminum and steel. Strong joints have been formed using a eutectic Al–Si brazing alloy. However, holding time must be kept as minimum as possible to avoid the formation of a second, more fragile Fe n Al m intermetallic layer [18]. Other processes A BSTRACT . The present study investigates the effect of joining parameters on the mechanical characteristics of dissimilar friction stir spot welding (FSSW) between aluminum alloys and galvanized steel. Mechanical performance has been evaluated by shear and microhardness testing. A macrostructural examination has revealed the creation of mechanical interlocking in the Al steel connections. Shear failure load has increased with increasing both tool rotational speed and plunge depth for all FSSW connections. Higher plunge depth has improved the mechanical interlocking between lower and upper sheet due to the formation of hook. K EYWORDS . Assembly; Friction stir spot welding; Aluminum alloy; Galvanized steel; Mechanical properties. Citation: Mekri, H., Bouchouicha, B., Miloudi, A., Christophe, H., Imad, A., Influence of the coupling between the mechanical characteristics and the welding conditions by the FSSW process: case of the bi-material aluminum-steel, Frattura ed Integrità Strutturale, 46 (2018) 62-72. Received: 07.03.2018 Accepted: 31.05.2018 Published: 01.10.2018 Copyright: © 2018 This is an open access article under the terms of the CC-BY 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original author and source are credited. T