Issue 50

M. Papachristoforou et alii, Frattura ed Integrità Strutturale, 50 (2019) 526-536; DOI: 10.3221/IGF-ESIS.50.44 534 4.88 7.64 6.79 5.95 4.95 2.87 5.29 5.19 4.75 4.54 0.00 2.00 4.00 6.00 8.00 10.00 Cement/LF Cement/FA/LF Cement/FA Cement/LFS/LF Cement/LFS 830 kg/m3 500 kg/m3 Elapsed time at cracking (days) Figure 10 : Time from molding to cracking for different mixtures. 0.00044 0.00024 0.00030 0.00030 0.00038 0.00068 0.00044 0.00042 0.00029 0.00028 0.0000 0.0002 0.0004 0.0006 0.0008 Cement/LF Cement/FA/LF Cement/FA Cement/LFS/LF Cement/LFS 830 kg/m3 500 kg/m3 Stress rate (MPa/day) Figure 11 : Stress rate at cracking for different mixtures. C ONCLUSIONS hree by-products, Fly ash, Ladle Furnace Slag and Limestone Filler, were used successfully in the production of concrete that can be applied with the 3D printing technique. Workability and rheology of fresh concrete was measured by three different tests. The flow table expansion test described in the EN 1015-3 was the most consistent one, and values of expansion between 18 and 24 cm were the optimum in order the mixture to be printed with the printing system used. Electric power consumption of the motor that rotates the screw extruder was the method used for measuring real-time workability of the mixtures, making it possible to modify it on time in real scale applications by adding chemical additives during printing. Regarding the type of materials used, mixtures with FA seem to lose more rapidly workability compared to mixtures with cement or cement and LFS as binder. However, this reduction of workability could possibly be addressed by using retarder admixtures. Regarding hardened concrete, ultrasonic pulse velocity showed very good correlation with compressive strength measured experimentally, proving that it can be a reliable non-destructive testing of estimating strength of concrete on 3D printed concrete structures. However, for 3D concrete performance testing, the engineers must take into account the interface zone between layers. Concerning the alternative binders used, when FA or LFS substituted 30% of cement, compressive strength dropped 20% and flexural strength 32%. Natural sand substitution by LF had minimum effect on strength development. On the contrary, shrinkage of concrete under restrained conditions was lower for mixtures produced with FA, LFS and LF. FA showed the best results (57% improvement compared to mixture with no SCMs) followed by mixtures with LFS (22% improve- ment compared to mixture with no SCMs). Utilization of LF again improved shrinkage behaviour, since time required for cracking increase by 12.5 to 20.5%. Overall, lower cracking potential of the mixtures with the by-products can compensate lower strength performance, especially in case of 3D printing plain concrete, where there is no steel reinforcement to bear tensile loads induced under restrained concrete shrinkage and further research is suggested. T