Issue 49

H. Berrekia et alii, Frattura ed Integrità Strutturale, 49 (2019) 643-654; DOI: 10.3221/IGF-ESIS.49.58 652 Déf-5 Déf-10 Déf-20 Déf-25 Déf-30 Déf-45 Déf-60 Déf-65 Déf-75 Déf-95 1 10 100 1000 10000 log 10 N Number of defects Number of cycles at crack initiation Number of cycles at rupture crack fracture Histogram : service life according to degree of corrosion (extension, width) The histogram groups the results of the lifetime obtained in number of cycles for each corrosion defect. The investigated pipeline has an initial cycle number N 0 of which the damage has appeared (initiation of crack). On the other hand, the pipeline considered can go up to a number NR of cycle (the maximum lifetime) related to the damage causing a rupture. It can be seen that the lifetime N 0 at crack initiation or N R at failure decrease when the extension and the width of the defect increase keeping a constant depth equal to 10% of the thickness of the pipe. It is also noted that the lifetimes increase in the case where the extension of the defect is important this can be explained by the increase in the loss of metal and the increase in the volume of the corrosion defect. This shows the effect of the extension of the corrosion defect on the lifetime of the pipe in the case where the depth remains low. The effect of the width of the defect remains negligible for a depth of the defect equal to 10% of the pipe thickness. Figure 9 shows the cycle variation at initiation as a function of the length and width of the corrosion defect during pipe service. It is noted that the lifetime at the initiation of a crack in the vicinity of the corrosion defect decreases when the length and width of the defect increase. 0 20 40 60 80 100 50 100 150 200 250 0 20 40 60 80 100 lifetime N 0 at initiation of ctack width of corrosion defect in mm Extension of corrosion defect Figure 9 : Number of cycles at initiation.