Issue 48

C.A.C.P. Coelho et alii, Frattura ed Integrità Strutturale, 48 (2019) 411-418; DOI: 10.3221/IGF-ESIS.48.39 417 R EFERENCES [1] Reis, P.N.B., Ferreira, J.A.M., Costa, J.D.M., Richardson, M.O.W. (2009). Fatigue life evaluation for carbon/epoxy laminate compositesunder constant and variable block loading, Compos. Sci. Technol., 69, pp. 154–160. DOI: 10.1016/j.compscitech.2008.09.043. [2] Reis, P.N.B., Neto, M.A., Amaro A.M. (2018). Effect of the extreme conditions on the tensile impact strength of GFRP composites, Compos. Struct., 188, pp. 48–54. DOI: 10.1016/j.compstruct.2018.01.001. [3] Adams, R.D., Cawley, P.D.R.D. (1998) A review of defects types and non-destructive testing techniques for composites and bonded joints, NDT&E Int., 21, pp. 208–222. DOI: 10.1016/0308-9126(88)90333-1. [4] Amaro, A.M., Reis, P.N.B., de Moura, M.F.S.F., Santos, J.B. (2012). Damage detection on laminated composite materials using several NDT techniques, Insight, 54, pp. 14–20. DOI: 10.1784/insi.2012.54.1.14. [5] de Moura, M.F.S.F., Marques, A.T. (2002). Prediction of low velocity impact damage in carbon-epoxy laminates, Compos. Part A Appl. S., 33, pp. 361–368. DOI: 10.1016/S1359-835X(01)00119-1. [6] Reis, P.N.B., Ferreira, J.A.M., Antunes, F.V., Richardson, M.O.W. (2009). Effect of interlayer dalamination on mechanical behavior of carbon/epoxy laminates, J. Compos. Mater., 43, 2609–2621. DOI: 10.1177 /0021998309344649. [7] Amaro, A.M., de Moura, M.F.S.F., Reis, P.N.B. (2006). Residual strength after low velocity impact in carbon-epoxy laminates, Mater. Sci. Forum, 514–516, pp. 624–628. DOI: 10.4028 /www.scientific.net/MSF.514-516.624. [8] Amaro, A.M., Reis, P.N.B., de Moura, M.F.S.F. (2011). Delamination effect on bending behaviour in carbon-epoxy composites, Strain, 47, pp. 203–208. DOI: 10.1111/j.1475-1305.2008.00520.x. [9] Richardson, M.O.W., Wisheart, M.J. (1996). Review of low-velocity impact properties of composite materials, Compos. Part A-Appl. S., 27, pp. 1123–1131. DOI: 10.1016/1359-835X(96)00074-7. [10] Río, T.G., Zaera, R., Barbero, E., Navarro, C. (2005). Damage in CFRPs due to low velocity impact at low temperature, Compos. Part B-Eng., 36, pp. 41–50. DOI: 10.1016/j.compositesb.2004.04.003. [11] Aktas, M., Atas, C., Icten, B.M., Karakuzu, R. (2009) An experimental investigation of the impact response of composite laminates, Compos. Struct., 87, pp. 307–313. DOI: 10.1016/j.compstruct.2008.02.003. [12] Dhakal, H.N., Zhang, Z.Y., Bennett, N., Reis, P.N.B. (2012). Low-velocity impact response of nonwoven hemp fibre reinforced unsaturated polyester composites: influence of impactor geometry and impact velocity, Compos. Struct., 94, pp. 2756–2763. DOI: 10.1016/j.compstruct.2012.04.004. [13] Kulkarni, M.D., Goel, R., Naik, N.K. (2011). Effect of back pressure on impact and compression after-impact characteristics of composites, Compos. Struct., 93, pp. 944–951. DOI: 10.1016/j.compstruct.2010.06.027. [14] Amaro, A.M., Reis, P.N.B., de Moura, M.F.S.F., Neto, M.A. (2013). Influence of multi-impacts on GFRP composites laminates, Compos. Part B-Eng., 52, pp. 93–99. DOI: 10.1016/j.compositesb.2013.03.041. [15] Amaro, A.M., Reis, P.N.B., Neto, M.A., Louro, C. (2013). Effects of alkaline and acid solutions on glass/epoxy composites, Polym. Degrad. Stabil., 98, pp. 853–862. DOI: 10.1016/j.polymdegradstab.2012.12.029. [16] Mortas, N., Er, O., Reis, P.N.B., Ferreira, J.A.M. (2014). Effect of corrosive solutions on composites laminates subjected to low velocity impact loading, Compos. Struct., 108, pp. 205–211. DOI: 10.1016/j.compstruct.2013.09.032. [17] Amaro, A.M., Reis, P.N.B., Neto, M.A. (2016). Experimental study of temperature effects on composite laminates subjected to multi-impacts, Compos. Part B-Eng., 98, pp. 23–29. DOI: 10.1016/j.compositesb.2016.05.021. [18] Aslan, Z., Karakuzu, R., Okutan, B. (2003). The response of laminated composite plates under low-velocity impact loading, Compos. Struct., 59, pp. 119–127. DOI: 10.1016/S0263-8223(02)00185-X. [19] Karakuzu, R., Erbil, E., Aktas, M. (2010). Impact characterization of glass/epoxy composite plates: An experimental and numerical study, Compos. Part B-Eng., 41, pp. 388–395. DOI: 10.1016/j.compositesb.2010.02.003. [20] Hosur, M.V., Adbullah, M., Jeelani, S. (2005). Studies on the low-velocity impact response of woven hybrid composites, Compos. Struct., 67, pp. 253–262. DOI: 10.1016/j.compstruct.2004.07.024. [21] Halvorsen, A., Salehi-Khojn, A., Mahinfalah, M., Nakhaei-Jazar, R. (2006). Temperature effects on the impact behavior of fiberglass and fiberglass/Kevlar sandwich composites, Appl. Compos. Mater., 13, pp. 369–383. DOI: 10.1007/s10443-006-9023-x. [22] Salehi-Khojin, A., Mahinfalaha, M., Bashirzadeh, R., Freeman, B. (2007). Temperature effects on Kevlar/hybrid and carbon fiber composite sandwiches under impact loading, Compos. Struct., 78, pp. 197–206. DOI: 10.1016/j.compstruct.2005.09.005. [23] Ávila, A.F., Soares, M.I., Neto, A.S. (2007). A study on nanostructured laminated plates behavior under low-velocity impact loadings, Int. J. Impact Eng., 34, pp. 28–41. DOI: 10.1016/j.ijimpeng.2006.06.009.