Issue 48

J. F. Barbosa et alii, Frattura ed Integrità Strutturale, 48 (2019) 400-410; DOI: 10.3221/IGF-ESIS.48.38 407 assert that the Logistic and Power Law formulations better describe the fatigue life behavior, due to the lack of data mainly in the high-cycle fatigue region. For a more complete analysis of this material, it is necessary to perform further experimental fatigue tests in stress levels between 400 MPa and 300 MPa. Regarding the fatigue data from the material of Fão bridge, two strain ratios, R, were explored, namely R=0 and R=-1 (fatigue test under strain-controlled conditions). The S-N Kohout-Věchet formulation and Power Law resulted in the lowest MSE values and very close to each other. The only perceptible difference in a qualitative analysis of the S-N curves at fatigue strain ratio equal to 0, is in the HCF region, where the possible extrapolation to the permanent fatigue limit of the Logistic S-N Curve would present a more adequate behaviour (Fig. 5). Figure 5 : Comparison of the S-N curves for the fatigue data of the metallic material from the Fão bridge, R=0 ( fatigue test under strain-controlled conditions) . Figure 6 : Comparison of the S-N curves for the fatigue data of the metallic material from the Fão bridge, R=-1 ( fatigue test under strain-controlled conditions). In Fig. 6, regarding the fatigue data of the Fão bridge at R=-1, the estimation in the LCF region of the Power Law, Logistic and Kohout-Věchet curves obtained similar and well-adjusted results, while in the HCF region the curve of Kohout-Věchet obtained better performance and consistent with fatigue limit. Based on Figs. 5 and 6, it is possible to report that the Kohout-Věchet curve presents better performance in the HCF region justified by high MSE values. One the other hand, the adjustment results based on the ASTM standard leads to an adjustment not consistent with the experimental results and when compared with the other models. 10 1 10 2 10 3 10 4 10 5 10 6 10 7 10 8 100 200 300 400 500 600 Max. Stress [MPa] N(Number of Cycles) Logistic Kohout-Vechet Power Law ASTM E739 Exp. Data Fão R=0 10 2 10 3 10 4 10 5 10 6 10 7 0 100 200 300 400 500 Max. Stress [MPa] N(Number of Cycles) Logistic Kohout-Vechet Power Law ASTM E739 Exp. Data Fão R=-1