Issue 46
G. B. Manjunatha et alii, Frattura ed Integrità Strutturale, 46 (2018) 14-24; DOI: 10.3221/IGF-ESIS.46.02 20 Source DF SS MS F P % of contribution A/W ratio 2 761.58 380.79 14.7 0.063 57.34 Thickness (mm) 2 471.69 235.84 9.16 0.098 35.1 Immersion Time (Days) 2 43.26 21.63 0.84 0.544 3.25 Error 2 51.51 25.76 3.87 Total 8 1328.04 100 Table 6 : ANOVA for Fracture toughness MPa m½. The main influencing factor on the fracture toughness is the a/w ratio about 57.34% because of decrement in load withstanding capacity as shown in Tab. 6. The thickness of the composite contributes about 35.1% to decrease the fracture toughness. This is due to the plastic zone size with increase in thickness [24]. And immersion time of 3.25% contributes to fracture toughness. It shows toughness alters very least by immersing the composite in sea water. The error of 3.87 % is due to fabrication defects. E XPERIMENTAL VALIDATION BY LINEAR REGRESSIONS o obtain the relationship between the load carrying capacity /fracture toughness and different parameter such as a/w ratio, width and thickness in general and a/w ratio, thickness and immersion time for seawater treatment, mathematical equations were developed. The regression coefficients in a mathematical model are estimated experimental responding. To investigation of these models, experiments are executed by taking an arbitrary combination of factor and matched with the predicted values. These mathematical equations with different control were obtained using statistical software MINITAB [25]. Mathematical Equations for ENT Test Load carrying capacity: 246- 500 A+ 30.9 T+ 1.67 I (1) Fracture toughness: 31.5 + 72.1 A – 1.12 T + 0.133I … .. (2) Mathematical Equations for SENB Test Load carrying capacity: 395- 550 A + 47.2 T – 1.19 I .... (3) Fracture toughness: 92.2 + 111 A – 3.25 T – 022 I …. (4) where, A= a/w ratio T= Thickness (mm) I= Immersion time (days) E XPERIMENTAL VALIDATION OF ENT TEST he comparison of load carrying capacity/fracture toughness from the mathematical model developed in the present work with values obtained experimentally. The Tab. 7 and Tab. 8 show the percentage of error from the experimental T T
Made with FlippingBook
RkJQdWJsaXNoZXIy MjM0NDE=