Issue 46

L. Sorrentino et alii, Frattura ed Integrità Strutturale, 46 (2018) 285-294; DOI: 10.3221/IGF-ESIS.46.26 288 panel of core DIAB P60 was cut to obtain six samples of 203 mm x 203 mm, their thickness was reduced from 20 mm to 8 mm by a vertical sawing machine and, then, theirs surfaces were cleaned through a jet of compressed air. Now, the adhesive was applied on a raw side of the stone, both sides of the composite laminate and both sides of the core DIAB P60 in a uniform way (see Fig. 1). Therefore, the stone was assembled to the composite sandwich and the obtained sample was put into some clamps in order to avoid the development of air bubbles and the leak of adhesive at the interface due to the excessive pressure. The samples were polymerized at room temperature for 120 minutes and at 63° C into an oven for further 120 minutes. Process to prepare the sample with core DIAB P60 and AF163-2k adhesive Three marble tiles and three granite tiles, whose dimensions were 200 mm x 200 mm x 10 mm, were brushed on the raw side by means of an abrasive paper and, then, they were cleaned by a cloth soaked in ethylic alcohol. The same operations were repeated on the composite laminate of 2.2 mm thickness, once cut through a band-saw at 205 mm x 205 mm. A panel of core DIAB P60 was cut to obtain six samples of 203 mm x 203 mm, their thickness was reduced from 20 mm to 8 mm by a milling machine and, then, theirs surfaces were cleaned through a jet of compressed air. Now, a film of adhesive was taken out the freezer and kept at room temperature for two hours. Then, it was cut at the dimensions of the tile and it was applied on the stone surface; then the composite laminate was put on the other side of the adhesive film. Another piece of adhesive was applied on the free composite laminate surface and the core DIAB P60 was put on the other side of the adhesive. A final piece of adhesive was applied to the free core surface and another composite laminate was put on the other side of the adhesive film. The obtained samples were put into a vacuum bag (see Fig. 2), previously lined with breather in order to support the vacuum distribution around the samples. The bag was sealed and the air was inhaled up to a pressure of 0.50 bar. Now, the bag was put into the oven and the temperature was increased of 4.95 °C per minute for twenty minutes, up to arrive at 135 °C; then, the temperature was kept constant for 1 hour. Finally, the oven was turned off and the bag was kept in pressure till the temperature reached 65°C. Figure 1 : Sample with core DIAB P60 and EC-2216 adhesive. Figure 2 : Process scheme for the manufacturing of sandwich structure with core DIAB P60 and AF163-2k adhesive.