Issue 44

Q.-C. Li et alii, Frattura ed Integrità Strutturale, 44 (2018) 35-48; DOI: 10.3221/IGF-ESIS.44.04 39 Figure 2 : Schematic diagram of multi-cluster staged fracturing for shale gas horizontal well and the established finite element model Two types of elements, CPE4P and COH2D4P, are used in the model. The CPE4P element can simulate the plane strain problem of porous elastic media, and the whole reservoir is assigned to this type of element. However, both the initiation and the propagation of cracks during hydraulic fracturing operation can be achieved by using COH2D4P element. The whole process of fracture propagation, fluid flow along the fracture and fluid leakage can be simulated by COH2D4P element when the fracturing fluid is injected into the formation. A total of 15,000 CPE4P elements and 800 COH2D4P elements are included in the model. The model is established by CAE module in ABAQUS software, and on this basis, the secondary development is carried out to realize the numerical simulation of crack propagation. In addition, in order to improve the accuracy of the simulation results and the convergence of the simulation process, the variable density method is used to realize the meshing of the model. That is, the elements near the cracks are more sophisticated and finely divided, which can be seen from Fig. 2. In terms of boundary conditions and initial conditions, the normal displacement of each boundary is fixed, and the pore pressure boundary is set to be constant along each boundary during the whole simulation process. The initial void ratio, initial stresses and initial pore pressure within the formation are defined by using the predefined field definition in ABAQUS FEM software. In addition, the transient coupling solution has been used for simulating the hydraulic fracturing process. Material Properties and construction parameters According to the mechanical parameters of shale reservoirs and the construction parameters for fracturing operations, factors affecting the interference between different fracturing clusters within the single hydraulic fracturing section are studied. The stratigraphic parameters and construction parameters used in simulation are shown in Tab. 1 and Tab. 2, respectively. Parameter Value Parameter Value Elastic Modulus, E / GPa 20 Poisson's ratio, ν 0.2 Maximum horizontal principal stress, σ H / MPa 27 Minimum horizontal principal stress , σ h / MPa 16 Vertical principal stress, σ V / MPa 27 Saturation, S o / % 100 Tensile strength, C / MPa 3 Initial porosity, ϕ / % 4 Initial pore pressure, P ip / MPa 10 Leakoff coefficient, l /m/s 1×10 -8 Permeability, K / m 2 5×10 -17 Length×Width / m 2 400×400 Table 1 : Model parameters of shale gas reservoir.