Issue 42

S. Seitl et alii, Frattura ed Integrità Strutturale, 42 (2017) 56-65; DOI: 10.3221/IGF-ESIS.42.07 58 accounted on this work to calculate fracture parameters, are presented in Section 3. The values of fracture parameters obtained through the empirical and numerical calibration curves are shown and discussed in Section 4. Finally, the conclusions of this work are given in Section 5. E XPERIMENTAL C AMPAIGN he experimental data used to obtain the two fracture parameters, K I and T -stress, by means of calibration curves from numerical simulations, presented in next Section, were attained in a previous paper by Cifuentes et al. [5]. That paper was focused on the reliability of MCT test for measuring the fracture energy ( G F ) on normal-strength (NSC) and high-strength concrete (HSC) comparing the results with those achieved from three-point bend (TPB) test. The fracture parameters will be calculated for the aforementioned normal strength concrete (NSC) and high strength concrete (HSC) whose constituents and mix proportions are shown in Tab. 1. Constituents NSC Content [kg/m 3 ] HSC Content [kg/m 3 ] Cement 376 500 Micro-silica - 75 Coarse aggregate (crushed limestone) <10 mm 580 990 Sand < 2 mm 739 660 Limestone powder < 2 mm 192 134 Water 545 105 Super-plasticizer 3.0 18.4 Flow spread (mm) 710 695 T 500 (s) 3.1 3.4 Table 1 : Constituents and mix proportions for NSC and HSC. The specimen geometry for MCT and TPB test are listed in Tab. 2. Three different types of MCT specimens were casted. From MCT1 to MCT3, the distance from the load axis to the backside of the specimen, W , measures 112.5 mm. For each type, specimens with three different relative notch length, α, (0.1, 0.3 and 0.5) were tested. Regarding TPB test, two type of specimens were accounted with a relative notch length, α, of 0.05 and 0.5. All specimens were manufactured for NSC and HSC to analyse the influence of testing on two different concrete strengths. Specimen MCT1 MCT2 MCT3 Specimen TPB1 TPB2 φ cs (mm) 153 153 153 D (mm) 100 100 φ sb (mm) 8 8 8 B (mm) 100 100 W (mm) 112.5 112.5 112.5 S (mm) 400 400 B (mm) 60 60 60 L (mm) 440 440 e (mm) 4 4 4 a 0 (mm) 5 50 A lig (mm 2 ) 6075 4725 3375 A lig (mm 2 ) 9714 5213 Table 2 : Dimensions of MCT and TPB specimens experimentally tested. To determine the mechanical properties of NSC and HSC the following tests were carried out. The compressive strength is determined from cube specimens of 100 mm side in accordance with UNE EN 12930-3:2009 [8]. The indirect tensile strength is obtained from splitting tests using 100 mm diameter by 200 long cylinders, according to UNE EN 12930-6:2010 [10]. The Young’s modulus is determined according to UNE EN 12390-13:2014 [7]. The mechanical properties for NSC T