Issue 38

U. Haider et alii, Frattura ed Integrità Strutturale, 38 (2016) 305-318; DOI: 10.3221/IGF-ESIS.38.41 310 0,000 0,040 0,080 0,120 0,160 0,001 0,01 0,1 1 10 100 Cumulative pore volume (cm 3 /g) Pore diameter (μm) 60% Raw fly ash 60% Second layer 60% Third layer 0,000 0,004 0,008 0,012 0,016 0,020 0,001 0,01 0,1 1 10 100 Differential pore volume (cm 3 /g) Pore diameter (μm) 60% Raw fly ash 60% Second layer 60% Third layer 0 5 10 15 20 25 0 5 10 15 20 25 30 Moisture content (%) Age (days) Pure cement 60% Raw fly ash 60% Second Layer 60% Third Layer Optical microscopic images were observed at 10 X magnification as shown in Fig. 3. As it can be noted in Fig. 3(a) raw fly ash particles consist of solid spherical, hollow spherical, and slaggy particles of various sizes ranging from 7.6 to 16.7 µm, 23.8 to 148 µm, and 63 to 505 µm, respectively. The first layer particle (Fig 3(b)) consists of mostly hollow spheres of sizes varying from 20 to 80 µm, whereas few solid spherical particles of almost the same size as hollow spherical particles. First layer particles are well known as cenospheres [42]. The second layer particles (Fig. 3(c)) consist of very fine rounded slaggy particles of size 8 to 30 µm, spherical particles of size 5 to 40 µm, and few hollow spherical particles of size 70 to 158 µm. The third layer particles (Fig. 3(d)) consists of mostly compact slaggy particles of measured sizes ranging from 27.2 to 566 µm, and few solid spherical particles of measured sizes 15.1 to 77.4 µm. To determine the porosity in each specimen it is necessary to determine the type of pores that exist in the hydrated cementitious specimens. Mercury intrusion porosimetry is well known method to determine pore size distribution of specimens and it was carried out to determine porosity of raw fly ash, second layer, and third layer cementitious specimens as shown in Fig. 4(a). Fig. 4(b) shows differential pore size distribution curves which are obtained by differentiating the curves in Fig. 4(a). In Fig. 4(b) it can be seen that samples containing raw fly ash, second layer, and third layer particles show the maximum concentration of pores at critical diameters of 0.065, 0.055, and 0.022 µm with differential peak volumes of 0.011, 0.018, and 0.011 cm 3 /g. (a) (b) (c) Figure 4 : Mercury intrusion porosity, cumulative pore volume vs pore diameter (a) , incremental / differential pore volume vs pore diameter (b) , and moisture content vs age of specimens (c) . Fig. 4(c) shows the moisture content exuded/discharged by the fully saturated specimens of raw fly ash, second, and third layer while in the oven. It can be seen in such a figure that as the age of drying is increased for fully saturated specimens, moisture is rapidly exuded by the specimens and after 14 days of drying the moisture curves are seen to be flat which means all moisture is discharged up to 14 days. It is seen here as well that specimens containing third layer particles Large capillary pores Gel pores Medium capillary pores Gel pores Large capillary pores Medium capillary pores