Issue 37

P. Velev et alii, Frattura ed Integrità Strutturale, 37 (2016) 272-279; DOI: 10.3221/IGF-ESIS.37.36 276 26.2 25.3 24.0 23.9 0.0 5.0 10.0 15.0 20.0 25.0 30.0 0.0 0.1 0.3 0.5 Magnetic nanoparticles, % Tensile strength , MPa Figure 5: Tensile strength of magnetic composites with different content of magnetic nanoparticles. The results for impact strength of the magnetic nanocomposites depending on the magnetic nanoparticles contents are presented in Fig. 6. 6.1 6.0 4.9 4.8 0.0 1.0 2.0 3.0 4.0 5.0 6.0 7.0 0.0 0.1 0.3 0.5 Magnetic nanoparticles, % Impact strength, kJ/m 2 Figure 6: Impact strength of magnetic composites with different content of magnetic nanoparticles. The increased content of magnetic nanoparticles in the composites leads to decreasing of the values for the impact strength. The lowest value (4.8 kJ/m 2 ) is obtained for the composites containing higher amount of magnetic nanoparticles - 0.5% . The results of magnetic composites for flexural strength are presented in Fig. 7. The results for flexural strength showed insignificant change in dependence on the magnetic nanoparticles content. The best results are obtained for the samples containing 0.1% nanoparticles (0.33MPa) and the lowest (0.23MPa) for the samples containing 0.5%. Tab. 2 presents the results for the specific volume ρ v [Ω.m] and surface ρ s [Ω] resistance. The increased amount of the magnetic nanoparticles in the composites leads to some decreasing of the specific volume and surface resistance. This trend allows the preparation and design of magnetic composites with desired conductivity.