Issue34

C. Fischer et alii, Frattura ed Integrità Strutturale, 34 (2015) 99-108; DOI: 10.3221/IGF-ESIS.34.10 100 concentration at the weld toe which depend on the load-carrying-grade of the weld, the weld flank angle and the layout of the intersecting plates. C ASE STUDY Selected Variants he two-sided transverse attachment (variant 1 in Fig. 1) under axial loading represents a simple welded joint. A crack would be initiated at one of the weld toes and would run through the loaded plate. The complex structure (variant 5) is the intersection of various plates joined by fillet welds. Here, the local hot-spot at the intersection point is critical since a crack would initiate at the weld toe on the surface of the horizontal plate in the loading condition shown. The other three variants are ‘intermediate’ geometries to separate the effects on crack propagation. They are described and used in the following. Corresponding three-dimensional finite element (FE) models taking advantage of the vertical symmetry plane were created in ANSYS ® 13.0. The models consist of solid elements with quadratic shape function (SOLID186), and the welds were completely modelled in order to account for the local stiffness. The models are 200 mm long, 100 mm wide and 70 mm high. No axial and angular misalignments are present and only the critical weld toe was rounded by a radius r ref = 1 mm for the determination of the stress field. The vertical nodal displacements of variants 1 and 5 were suppressed at the bottom. On the symmetry plane corresponding boundary conditions were applied, and the transverse nodal displacement was coupled on the opposite side to represent adjacent structures. The front and back face were loaded by uniform, axial stresses, whereas the axial nodal displacements were suppressed at the back face of the complex structure. F F crack at weld toe crack at weld toe F F M F M F M 100 variant 2 – transverse attachment w. gradient variant 4 – add. long. attachment variant 1 – transverse attachment crack at weld toe crack at weld toe variant 3 - supported transverse attachment crack at weld toe variant 5 – complex structure Figure 1 : Selected geometrical variants (variants 1 to 4 are cut in the symmetry plane). Structural Hot-Spot Stress and Effective Notch Stress Both stresses are commonly used for fatigue assessment of welded joints (see e.g. [10]) and are the basis for comparing the variants. The structural hot-spot stress (HSS) σ s which appears in front of the rounded weld toe on the symmetry plane consists of the sum of the membrane stress σ m and bending stress σ b . Both σ m and σ b are determined by linearizing the axial stress component over the plate thickness t = 10 mm according to [10]. Moreover, Dong [3] characterized a stress gradient occurring over the plate thickness by means of the degree of bending  , Eq. (1). Here,  = 0 denotes pure axial loading and  = 1 pure bending. b m b       (1) T

RkJQdWJsaXNoZXIy MjM0NDE=