numero26

M. Grasso et alii, Frattura ed Integrità Strutturale, 26 (2013) 69-79; DOI: 10.3221/IGF-ESIS.26.08 70 data produced by Virkler and co-workers [11] and those recently produced by Wu and Ni [12]. For this reason the model has been modified introducing two more parameters. The positive verification of the new model by means of both the cited data and those discussed in [13] closes the paper. E XPERIMENTAL DATA ANALYSED he methods developed to interpolate crack propagation data, besides those proposed by the ASTM Standard [1], are essentially based on the preliminary choice of a technique or a method to interpret the experimental raw data, i.e. crack length values as function of time or load cycles, to establish a correlation between the observed variables. Generally, they essentially are local interpolation methods of the data, which are not able to filter the irregularities or anomalies characterizing this type of measurements. Since the evolution of the propagation phenomenon is progressively faster when the crack approaches the critical condition, propagation models built on results obtained from a limited number of tests not only have a validity range closely linked to the particular experimentation carried out, but they are also not able to fit all crack growth data with the same accuracy for the whole field of cycles number of each test [9]. In order to work out a new analytical model of the link between crack length and the corresponding number of cycles overcoming the drawbacks observed with previous models, several fatigue crack growth data sets obtained with different materials, loading conditions and type of specimens have been analyzed and interpolated. In the following sections the main aspects of the testing activities carried out by authors of the different data sources are reported. Ghonem and Dore data [10] To analyse the validity of their Markov Chain crack growth model, Ghonem and Dore carried out tests at room temperature using M(T) specimens made of aluminium alloy 7075-T6 having the same thickness (3.175 mm) of the sheet from which they were extracted. The crack direction was perpendicular to the rolling direction of the sheet. Loading conditions applied after the precracking phase are reported in Tab. 1. N. 60 specimens were been tested under each loading level. Data set P max (kN) P min (kN) ΔP(kN) R Test I 22.79 13.68 9.11 0.6 Test II 22.25 11.13 11.12 0.5 Test III 15.19 6.08 9.11 0.4 Table 1 : Loading Conditions related to Ghonem and Dore tests. Virkler et Al. data [11] Experimental activity of Virkler et Al. was aimed at:  determining which crack growth rate calculation method yields the least amount of error when the crack growth rate curve is integrated back to obtain the original a versus N curve data;  determining the statistical distribution of N as a function of the crack length;  determining the statistical distribution of da/dN as a function of ΔK;  determining the variance of a set of a versus N curves predicted from the da/dN distribution parameters. Crack growth testing was carried out on a sample of n.68 M(T) specimens, 558.8 mm long and 152.4 mm wide, made of aluminium alloy 2024-T3 and extracted from a sheet having thickness equal to 2.54 mm. The crack starter was machined with an electro-discharge machine. All tests were conducted under the same experimental conditions and with the loading level reported in Tab. 2. P max (kip) P min (kip) ΔP(kip) R Test I 5.25 1.05 4.2 0.2 Table 2 : Loading Conditions related to Virkler tests. T