#### General Papers

A complex variable formulation for the interactions between rigid inclusions and cracks | |

K. T. Chau, W. B. Wang |

A simple method for topology optimization using orthotropic material properties | |

Z. Wu, Y. Sogabe, Y. Arimitsu |

A study of fracture from the viewpoint of dilatation | |

Y. Arimitsu, Y. Sogabe, Z. Wu |

Alternative methods for deriving and fitting J-R curves: How they affect structural integrity assessment | |

J. R. Tarpani, A. A. Colafemea, W. W Bose Filho, D. Spinelli |

An experimental investigation of dynamic inelastcity and fracture of nanostructured coatings | |

H. Espinosa, Z. Wu |

Analysis of fracture mechanics and fatigue behaviour for EC(T) specimen | |

J. Z. Liu, X. R. Wu, B. R. Hu, L. F. Wang |

Assessment of fracturing tunnel linings with smeared crack model | |

Z. S. Wu, J. Yin, T. Asakura, Y. Kojima |

Cohesive and adhesive fracture under nanoscale contacts: Environmental and microstructural effects | |

N. I. Tymiak, A. Daugela, M. Li, T. J. Wyrobek, W. W. Gerberich |

Composite laminates least prone to cracking under combined mechanical and thermal loads | |

B. L. Karihaloo, J. Wang |

Computational modelling of cracks in viscoplastic media | |

G. N. Wells, L. J. Sluys, R. de Borst |

Computational modelling of residual stress effects on crack initiation and growth in ductile materials | |

N. P. O'Dowd, Y. Lei, P. S. May, G. A. Webster |

Creep fracture of ceramic-matrix composites | |

B. Wilshire, H. Burt |

Crystallographic analysis of surfaces after brittle fracture in ferritic steels | |

V. Randle, P. Davies, O. Williams |

Determination of microstructural parameters for modeling of fatigue behavior in ceramics | |

K. White |

Digital speckle correlation test for fracture of thin film | |

H. Wang, Y. Kang |

Double cohesive zone model and prediction of micro-scratch testing along solid surface | |

M. Zhao, Y. Wei, J. W. Hutchinson |

Dynamic fracture and fragmentation brittle spheres subject to double impact test | |

K. T. Chau, S. Z. Wu, X. X. Wei |

Dynamic tensile strength of PMMA/AL plate butt adhesive joints | |

H. Wada, S. Kubo, K. Murase, T. C. Kennedy |

Effects of plastic strain on cleavage fracture predictions in steel | |

S. R. Bordet, A. D. Karstensen, C. S. Wiesner, D. M. Knowles |

Equilibrium length of a Zener-Barenblatt nanocrack wedged open by a disclination dipole | |

M. S. Wu |

Evaluation of a brittle fracture accidents that occurred at the Hyogo-Ken Nanbu earthquake | |

M. Toyosada, K. Gotoh, Y. Watanabe, S. Nakayama |

Experimental and analytical studies on peeling behaviour and spalling resistance effect of externally bonded continuous fiber sheets | |

Z. Wu, T. Asakura, H. Yoshizawa, H. Yuan, A. Kobayashi, T. Takahashi |

Fatigue and hydrogen cracking in cannons with mechanical and thermal residual stresses | |

J. H. Underwood, A. P. Parker, E. Troiano, G. N. Vigilante, M. D. Witherell |

Fatigue behaviour of a laser beam welded Ni-base superalloy during high temperature cyclic deformation | |

T. Spirowski, A. Fischer, R. Saggau, H. Pries, H. Wohlfahrt |

Fatigue crack growth with tensile residual stresses | |

Y. Prawoto, R. A. Winholtz |

Fracture behavior of conductive cracks in PZT-4 piezoelectric ceramics | |

T. H. Wang, R. Fu, T. Y. Zhang |

Fracture behaviour of a SiCw/6061Al alloy composite under cyclic loading | |

L. Wang, T. Kobayashi, Z. M. Sun, H. Toda |

Fracture behaviour of blends consisting of asymmetric styrene/butadiene block copolymers | |

R. Adhikari, R. Lach, G. H. Michler, R. Weidisch, W. Grellmann |

Fracture in chromium: an attempt to improve ductility | |

R. Wadsack, R. Pippan, B. Schedler |

Fracture in metakaolin concrete under different loading conditions | |

B. B. Sabir, S. Wild |

Fracture mechanics and durability of high performance concrete | |

F. H. Wittmann |

Fracture mechanics characterisation of epoxy resins by means of mini-compact-tension-specimens | |

C. Bierogel, H. Walter, W. Grellmann, H. Henning, B. Michel |

Fracture mechanics evaluation of post yield fatigue crack initiation and propagation | |

G. S. Wang, A. F. Blom |

Fracture toughness and failure mechanism of polymer-introduced porous Hap composites | |

H. Suemasu, T. Wada, M. Aizawa, K. Gozu, A. Nozue, K. Itatani |

Fracture toughness characterization of hydrogen embrittled Cr-Mo steel | |

Y. Wada, Y. Tanaka |

Fracture toughness of niobium/sapphire interfaces: effect of interface doping and ion assisted deposition | |

G. S. Was, H. Ji |

Hydrogen, Hydrides, and Crack Tip Deformation in Titanium | |

C. L. Briant, Z. F. Wang, K. S. Kumar |

Interfacial force microscopy studies of y-APS on glass and SI02 | |

K. M. Liechti, K. C. Vajapeyajula, M. Wang, H. Cabibil, H. Celio, J. M. White |

Kic - a non measure of plane strain fracture toughness | |

K. Wallin |

Low cycle fatigue of alumina | |

M. T. Kokaly, A. S. Kobayashi, K. W. White |

LRM constitutive model for describing functionally graded material with fast propagating crack | |

M. Nakagaki, Y. Wu |

Modelling the effects of microstructure and microtexture on the statistics of short fatigue crack growth | |

A. J. Wilkinson |

Near the fatigue limit in glass | |

S. Wiederhorn |

New considerations and results on crack separation energy rated in elastic-plastic fracture mechanics | |

Y. Wadier, E. Lorentz |

Notch fracture of MEMS sensors made of single crystal silicon | |

Z. L. Zhang, W. Westby, T. Wang |

Notch strength and notch sensitivity of polymethyl methacrylate | |

H. Wang, J. Yan, X. Zheng |

Numerical modelling of ceramic materials microstructures for residual stresses concentrations | |

T. Niezgoda, W. Szymczyk, J. Malachowski, M. Woropay |

On the detection of fatigue damage prior to surface indication | |

G. Wheatley, D. Barton, K. Davey |

Oxygen enhanced crack growth in nickel-base superalloys under sustained and fatigue loading | |

R. Wei, Z.-F. Huang, C. Miller, G. W. Simmon |

Plastically dominant / elastically dominant fatigue interaction | |

Y. K. Wong, X. Z. Hu, M. P. Norton |

Prediction of ductile crack growth in polyethylene using measured traction-separation curves | |

J. G. Willams, K. C. Pandya, A. Ivankovic |

Prediction of probability distribution of notch strength of ceramics | |

J. Yan, X. L. Zheng, K. Zhao, H. Wang |

Re-examination of over specified condition of stress intensity factor for multi-material wedges and junctions | |

W.-C. Wang, S.-W. Lin |

Self-consistent constitutive modeling of particle dispersed composite materials with micro-crack type damage | |

M. Nakagaki, H. Chang, Y. Wu |

Self-Healing Polymer Composites | |

S. White, E. N. Brown, M. R. Kessler, S. Sriram |

Simulation of fatigue crack propagation rates in smooth bending specimens, from the onset of loading, using the two-term model | |

H. Saguy, M. P. Weiss, D. Rittel |

Simulation of probability distribution of fatigue life of notched friction welded joints under variable-amplitude loading | |

J . an, X. L. Zheng, K. Zhao, H. Wang |

Spatial statistics of particle clusters and modelling of pitting corrosion | |

D. Harlow, R. P. Wei |

Statistical Study of Fracture in Concrete | |

T. K. Wang, J. M. C. van Mier, T. N. Bittencourt |

Stress intensity factor error index for finite element analysis with singular elements | |

T. Meshii, K. Watanabe |

Tensile and fatigue fracture of discontinuously reinforced aluminum alloys (DRA) | |

N. Chawla, J. J. Williams, G. Piotrowski, R. Saha |

The branching angle of dynamic crack propagation | |

M. Watanabe |

The formulae of fatigue crack propagation in polymethyl methacrylate | |

H. Wang, J. Yan, X. Zheng |

The fracture toughness properties of large upset resistance stainless steel welds | |

M. J. Morgan, S. L. West, W. R. Kanne Jr, G. K. Chapman |

The influence of lattice distortion region near the grain boundary on mechanical properties in nanocyrstalline materials | |

X. Wang, J. Wang, J. Rifkin, D. Li |

The influence of thermal residual stresses and friction on fatigue crack growth in fibre-reinforced intermetallic matrix composites | |

G. Rauchs, P. J. Withers, P.F. Thomason |

The relationship between the median/radial and lateral cracks of vickers indents in soda-lime-silica-glass | |

B. R. Whittle, R. J. Hand |

The use of water-based epoxy resin coating for strengthening glass | |

B. R. Whittle, R. J. Hand, B. Ellis |

Thermal shock fracture behaviour of ceramics characterized by disc-on-rod tests | |

S. Wakayama, K. Nishino, S. Arai |