General Papers
| Mesoscopic simulations of damage accumulation under fatigue loading | |
| A Brückner-Foit, X. Huang, Y. Motoyashiki |
| Effects of the length of the damage zone on the effective constitutive properties of an adhesive layer loaded in peel | |
| T. Andersson,, A. Biel |
| Numerical analysis of the performances of the bonded composite patch for reducing stress concentration and repairing cracks at notch | |
| B. Bachir Bouiadjra, B. Serier, D. Ouinas, B. Boutabout |
| Dynamic mechanical properties of ductile cast iron materials for thick walled components | |
| W. Baer, R. Häcker, J. Börrnert |
| Numerical analysis of cracked rolling contact components | |
| M. Beghini, L. Bertini, V. Fontanari |
| The role of bi-modal and lamellar microstructures of TI-6AL-4V on the behavior of fatigue cracks emanating from edge-notches | |
| M. Benedetti, V. Fontanari |
| Multiaxial fatigue and defect assessment of truck stabilizers | |
| S. Beretta, H. Desimone, A. Poli |
| Steady-state measurement of the interface fracture resistance in wafer bonding | |
| Y. Bertholet, F. Iker, X. X. Zhang, J .P. Raskin, T. Pardoen |
| Mode I and mixed-mode I/II crack tip fields unified by constraint | |
| B. Bezensek, J. W. Hancock |
| Influence of varying load spectra on short crack growth modelled by a dislocation technique | |
| C. Bjerkén,, S. Melin |
| Conventional vs closure free crack growth in nodular iron | |
| A. Bjoerkblad |
| Prediction of the DT41J and DKIc,100 shifts due to irradiation for an A508 pressure vessel steel based on local approach to fracture | |
| C. Bouchet, B. Tanguy, J. Besson, S. Bugat |
| Optimising energy input for fracture by analysis of the energy required to initate dynamaic mode I crack growth | |
| V. Bratov, Y. Petrov |
| Modelling and experimental verification of delamination crack growth in an air-plasma-sprayed thermal barrier coating | |
| H. Brodin, M. Jinnestrand, M. Jinnestrand, S. Sjöström, S. Sjöström |
| Assessment of load history effects on fracture | |
| P. J. Budden, D. C. Connors |
| Fatigue behaviour of clinched joints | |
| M. Carboni, S. Beretta, M. Monno |
| Modelling of the mechanical behaviour and fracture processes of the PVDF | |
| M. Challier, J. Besson, S. Cantournet, L. Laiarinandrasana, R. Piques, R. G. Hochstetter, S. Pignoc |
| Assessment of load history effects on fracture | |
| P. J. Budden, D. C. Connors. |
| Conventional vs closure free crack growth in nodular iron | |
| A. Bjoerkblad. |
| Crack tip stress fields for anisotropic materials with cubic symmetry | |
| D .E. Lempidaki, N. P. O'Dowd, E. P. Busso. |
| Creep failure model of a 9Cr-1MoNbV (P91) steel integrating multiple deformation and damage mechanisms | |
| V. Gaffard, J. Besson, A. F. Gourgues. |
| Dynamic mechanical properties of ductile cast iron materials for thick walled components | |
| W. Baer, R. Häcker, J. Börrnert. |
| Effects of the length of the damage zone on the effective constitutive properties of an adhesive layer loaded in peel | |
| T. Andersson, A. Biel. |
| Elastic-plastic analysis of cracks in pipe | |
| K. Kaddouri, B. Bachir Bouaidjra, M. Belhouari, K. Madani. |
| Fatigue behaviour of clinched joints | |
| M. Carboni, S. Beretta, M. Monno. |
| Fatigue crack paths and residual stresses in cold formed rectangular structural tubes | |
| S. Heinilä, T. Björk, G. Marquis, M. Bäckström, R. Ilvonen. |
| Fracture resistance degradation of hybrid galss matrix composites | |
| I. Dlouhy, Z. Chlup, A. R. Boccaccini. |
| Influence of varying load spectra on short crack growth modelled by a dislocation technique | |
| C. Bjerkén, S. Melin. |
| J-T Characterization of elastic-plastic stress fields in a mode II crack specimen | |
| K. Madani, B. Bachir Bouiadjra, M. Belhouar, B. Serier. |
| Micro-mechanical damage modelling of notched bar testing of modern pipe steel | |
| A. Brückner-Foit, X. Huang, Y. Motoyashiki |
| Modeling of fracture of structural components with zones of corrosion wear under thermomechanical loading | |
| B. Bezensek, J. W. Hancock. |
| Modelling drop impact and fracture of fluid-filled plastic containers | |
| H. Brodin, M. Jinnestrand, S. Sjöström. |
| Multiscale simulation of the competition between intergranular and transgranular fracture in 7000 alloys | |
| S. Beretta, H. Desimone, A. Poli. |
| Non-propagating cracks under in-phase mode I and II loadings | |
| F. Scheyvaerts, P. R. Onck, Y. Bréchet, T. Pardoen |
| Numerical analysis of the performances of the bonded composite patch for reducing stress concentration and repairing cracks at notch | |
| M. Beghini, L. Bertini, V. Fontanari. |
| Numerical investigations of the fatigue crack growth under service loading | |
| B. Bachir Bouiadjra, B. Serier, D. Ouinas, B. Boutabout. |
| Phenomenological assessment of temper embrittlement at 21/4Cr-1Mo steel | |
| V. Bratov, Y. Petrov. |
| Strain energy density parameter approach to the non-local parameter of fatigue damage | |
| Y. Bertholet, F. Iker, X. X. Zhang, J .P. Raskin, T. Pardoen. |
| The transferability of micro-mechanical damage parameters in modern line pipe steel | |
| M. Benedetti, V. Fontanari. |