General Papers
| A complex variable formulation for the interactions between rigid inclusions and cracks | |
| K. T. Chau, W. B. Wang |
| A simple method for topology optimization using orthotropic material properties | |
| Z. Wu, Y. Sogabe, Y. Arimitsu |
| A study of fracture from the viewpoint of dilatation | |
| Y. Arimitsu, Y. Sogabe, Z. Wu |
| Alternative methods for deriving and fitting J-R curves: How they affect structural integrity assessment | |
| J. R. Tarpani, A. A. Colafemea, W. W Bose Filho, D. Spinelli |
| An experimental investigation of dynamic inelastcity and fracture of nanostructured coatings | |
| H. Espinosa, Z. Wu |
| Analysis of fracture mechanics and fatigue behaviour for EC(T) specimen | |
| J. Z. Liu, X. R. Wu, B. R. Hu, L. F. Wang |
| Assessment of fracturing tunnel linings with smeared crack model | |
| Z. S. Wu, J. Yin, T. Asakura, Y. Kojima |
| Cohesive and adhesive fracture under nanoscale contacts: Environmental and microstructural effects | |
| N. I. Tymiak, A. Daugela, M. Li, T. J. Wyrobek, W. W. Gerberich |
| Composite laminates least prone to cracking under combined mechanical and thermal loads | |
| B. L. Karihaloo, J. Wang |
| Computational modelling of cracks in viscoplastic media | |
| G. N. Wells, L. J. Sluys, R. de Borst |
| Computational modelling of residual stress effects on crack initiation and growth in ductile materials | |
| N. P. O'Dowd, Y. Lei, P. S. May, G. A. Webster |
| Creep fracture of ceramic-matrix composites | |
| B. Wilshire, H. Burt |
| Crystallographic analysis of surfaces after brittle fracture in ferritic steels | |
| V. Randle, P. Davies, O. Williams |
| Determination of microstructural parameters for modeling of fatigue behavior in ceramics | |
| K. White |
| Digital speckle correlation test for fracture of thin film | |
| H. Wang, Y. Kang |
| Double cohesive zone model and prediction of micro-scratch testing along solid surface | |
| M. Zhao, Y. Wei, J. W. Hutchinson |
| Dynamic fracture and fragmentation brittle spheres subject to double impact test | |
| K. T. Chau, S. Z. Wu, X. X. Wei |
| Dynamic tensile strength of PMMA/AL plate butt adhesive joints | |
| H. Wada, S. Kubo, K. Murase, T. C. Kennedy |
| Effects of plastic strain on cleavage fracture predictions in steel | |
| S. R. Bordet, A. D. Karstensen, C. S. Wiesner, D. M. Knowles |
| Equilibrium length of a Zener-Barenblatt nanocrack wedged open by a disclination dipole | |
| M. S. Wu |
| Evaluation of a brittle fracture accidents that occurred at the Hyogo-Ken Nanbu earthquake | |
| M. Toyosada, K. Gotoh, Y. Watanabe, S. Nakayama |
| Experimental and analytical studies on peeling behaviour and spalling resistance effect of externally bonded continuous fiber sheets | |
| Z. Wu, T. Asakura, H. Yoshizawa, H. Yuan, A. Kobayashi, T. Takahashi |
| Fatigue and hydrogen cracking in cannons with mechanical and thermal residual stresses | |
| J. H. Underwood, A. P. Parker, E. Troiano, G. N. Vigilante, M. D. Witherell |
| Fatigue behaviour of a laser beam welded Ni-base superalloy during high temperature cyclic deformation | |
| T. Spirowski, A. Fischer, R. Saggau, H. Pries, H. Wohlfahrt |
| Fatigue crack growth with tensile residual stresses | |
| Y. Prawoto, R. A. Winholtz |
| Fracture behavior of conductive cracks in PZT-4 piezoelectric ceramics | |
| T. H. Wang, R. Fu, T. Y. Zhang |
| Fracture behaviour of a SiCw/6061Al alloy composite under cyclic loading | |
| L. Wang, T. Kobayashi, Z. M. Sun, H. Toda |
| Fracture behaviour of blends consisting of asymmetric styrene/butadiene block copolymers | |
| R. Adhikari, R. Lach, G. H. Michler, R. Weidisch, W. Grellmann |
| Fracture in chromium: an attempt to improve ductility | |
| R. Wadsack, R. Pippan, B. Schedler |
| Fracture in metakaolin concrete under different loading conditions | |
| B. B. Sabir, S. Wild |
| Fracture mechanics and durability of high performance concrete | |
| F. H. Wittmann |
| Fracture mechanics characterisation of epoxy resins by means of mini-compact-tension-specimens | |
| C. Bierogel, H. Walter, W. Grellmann, H. Henning, B. Michel |
| Fracture mechanics evaluation of post yield fatigue crack initiation and propagation | |
| G. S. Wang, A. F. Blom |
| Fracture toughness and failure mechanism of polymer-introduced porous Hap composites | |
| H. Suemasu, T. Wada, M. Aizawa, K. Gozu, A. Nozue, K. Itatani |
| Fracture toughness characterization of hydrogen embrittled Cr-Mo steel | |
| Y. Wada, Y. Tanaka |
| Fracture toughness of niobium/sapphire interfaces: effect of interface doping and ion assisted deposition | |
| G. S. Was, H. Ji |
| Hydrogen, Hydrides, and Crack Tip Deformation in Titanium | |
| C. L. Briant, Z. F. Wang, K. S. Kumar |
| Interfacial force microscopy studies of y-APS on glass and SI02 | |
| K. M. Liechti, K. C. Vajapeyajula, M. Wang, H. Cabibil, H. Celio, J. M. White |
| Kic - a non measure of plane strain fracture toughness | |
| K. Wallin |
| Low cycle fatigue of alumina | |
| M. T. Kokaly, A. S. Kobayashi, K. W. White |
| LRM constitutive model for describing functionally graded material with fast propagating crack | |
| M. Nakagaki, Y. Wu |
| Modelling the effects of microstructure and microtexture on the statistics of short fatigue crack growth | |
| A. J. Wilkinson |
| Near the fatigue limit in glass | |
| S. Wiederhorn |
| New considerations and results on crack separation energy rated in elastic-plastic fracture mechanics | |
| Y. Wadier, E. Lorentz |
| Notch fracture of MEMS sensors made of single crystal silicon | |
| Z. L. Zhang, W. Westby, T. Wang |
| Notch strength and notch sensitivity of polymethyl methacrylate | |
| H. Wang, J. Yan, X. Zheng |
| Numerical modelling of ceramic materials microstructures for residual stresses concentrations | |
| T. Niezgoda, W. Szymczyk, J. Malachowski, M. Woropay |
| On the detection of fatigue damage prior to surface indication | |
| G. Wheatley, D. Barton, K. Davey |
| Oxygen enhanced crack growth in nickel-base superalloys under sustained and fatigue loading | |
| R. Wei, Z.-F. Huang, C. Miller, G. W. Simmon |
| Plastically dominant / elastically dominant fatigue interaction | |
| Y. K. Wong, X. Z. Hu, M. P. Norton |
| Prediction of ductile crack growth in polyethylene using measured traction-separation curves | |
| J. G. Willams, K. C. Pandya, A. Ivankovic |
| Prediction of probability distribution of notch strength of ceramics | |
| J. Yan, X. L. Zheng, K. Zhao, H. Wang |
| Re-examination of over specified condition of stress intensity factor for multi-material wedges and junctions | |
| W.-C. Wang, S.-W. Lin |
| Self-consistent constitutive modeling of particle dispersed composite materials with micro-crack type damage | |
| M. Nakagaki, H. Chang, Y. Wu |
| Self-Healing Polymer Composites | |
| S. White, E. N. Brown, M. R. Kessler, S. Sriram |
| Simulation of fatigue crack propagation rates in smooth bending specimens, from the onset of loading, using the two-term model | |
| H. Saguy, M. P. Weiss, D. Rittel |
| Simulation of probability distribution of fatigue life of notched friction welded joints under variable-amplitude loading | |
| J . an, X. L. Zheng, K. Zhao, H. Wang |
| Spatial statistics of particle clusters and modelling of pitting corrosion | |
| D. Harlow, R. P. Wei |
| Statistical Study of Fracture in Concrete | |
| T. K. Wang, J. M. C. van Mier, T. N. Bittencourt |
| Stress intensity factor error index for finite element analysis with singular elements | |
| T. Meshii, K. Watanabe |
| Tensile and fatigue fracture of discontinuously reinforced aluminum alloys (DRA) | |
| N. Chawla, J. J. Williams, G. Piotrowski, R. Saha |
| The branching angle of dynamic crack propagation | |
| M. Watanabe |
| The formulae of fatigue crack propagation in polymethyl methacrylate | |
| H. Wang, J. Yan, X. Zheng |
| The fracture toughness properties of large upset resistance stainless steel welds | |
| M. J. Morgan, S. L. West, W. R. Kanne Jr, G. K. Chapman |
| The influence of lattice distortion region near the grain boundary on mechanical properties in nanocyrstalline materials | |
| X. Wang, J. Wang, J. Rifkin, D. Li |
| The influence of thermal residual stresses and friction on fatigue crack growth in fibre-reinforced intermetallic matrix composites | |
| G. Rauchs, P. J. Withers, P.F. Thomason |
| The relationship between the median/radial and lateral cracks of vickers indents in soda-lime-silica-glass | |
| B. R. Whittle, R. J. Hand |
| The use of water-based epoxy resin coating for strengthening glass | |
| B. R. Whittle, R. J. Hand, B. Ellis |
| Thermal shock fracture behaviour of ceramics characterized by disc-on-rod tests | |
| S. Wakayama, K. Nishino, S. Arai |