Issue 42

M. Peron et alii, Frattura ed Integrità Strutturale, 42 (2017) 205-213; DOI: 10.3221/IGF-ESIS.42.22 206 experimental results on notched components, that represents a great gap since notches greatly affect the mechanical behavior [12–15] , the detrimental effect of the zinc layer on the fatigue strength cannot be quantified yet, neither in [11], since a direct comparison between uncoated and hot-dip galvanized notched specimens was not performed. Furthermore, though hot-dip galvanization is widely used to enhance the corrosion resistance of welded joints, none researchers have interested in assessing the effect of this surface treatment on their fatigue behavior. Thus, the aim of this work is to fill these lacks, by means of experimental fatigue tests on uncoated and hot-dip galvanized fillet welded cruciform joints made of structural steel S355. The results report the harmful effect of the presence of zinc layer on fatigue strength both in terms of stress range Δ σ and of the averaged strain energy density range W  in a control volume of radius R 0 = 0.28 mm. Figure 1 : Geometry of the fillet welded cruciform specimen and typical fracture surface. E XPERIMENTAL DETAILS he steel plates used to fabricate the samples were 10 mm in thickness, while the complete specimen had a global length of 250 mm. The complete geometry of the specimen can be seen in Fig. 1. Fatigue tests have been conducted on transverse non-load carrying fillet welded joints, made of S 355J2+N structural steel. Welding beads have been made by means of automatic MAG (Metal Active Gas) technique. One of the two series of welded joints has been later hot dip galvanized. Tests have been performed on a servo-hydraulic MTS 810 test system with a load cell capacity of 250 kN at 10 Hz frequency, in air, at room temperature. All samples have been tested using a sinusoidal signal in uniaxial tension (plane loading) and a load ratio R = 0, under remote force control. Regarding the galvanized series, the coating treatment has been carried out at a bath temperature of 452 o C and the immersion time was kept equal to 4 minutes for all the specimens. As a consequence, the coating thickness resulted in a range between 96 and 104 μm. R ESULTS atigue tests results are here presented in terms of the stress range Δ σ = σ max - σ min versus the number of cycles to failure, in a double logarithmic scale. The stress range is referred to the nominal area (400 mm 2 ). Failure has always occurred at the weld toe, as expected, with a typical fracture surface as that shown in Fig. 1. The results from the tests were statistically elaborated by using a log-normal distribution. The ‘run-out’ samples, over two million cycles, were not included in the statistical analysis and are marked in the graphs with an arrow. Fig. 2 refers to uncoated and coated series, while Fig. 3 shows all the data elaborated together: in addition to the mean curve relative to a survival probability of Ps = 50%, (Wöhler curve) the scatter band defined by lines with 10% and 90% of probability of survival (Haibach scatter band) is also plotted. The mean stress amplitude values corresponding to two million cycles, the inverse slope k value of the Wöhler curve and the scatter index T σ (the ratio between the stress amplitudes corresponding to 10% and 90% of survival probability) are provided in the figure. For the complete listing of the results of the fatigue tests, please refer to Tab. 1. T F