Issue 41

F. Berto, Frattura ed Integrità Strutturale, 41 (2017) 475-483; DOI: 10.3221/IGF-ESIS.41.59 475 Cracked components under anti-plane loading: recent outcomes and future developments F. Berto Norwegian University of Science and Technology - NTNU, Department of Engineering Design and Materials, Trondheim, 7491, Norway A BSTRACT . The existence of three-dimensional effects at cracks has been known for many years, but understanding has been limited, and for some situations still is. Understanding improved when the existence of corner point singularities and their implications became known. Increasingly powerful computers made it possible to investigate three-dimensional effects numerically in detail. Despite increased understanding, three-dimensional effects are sometimes ignored in situations where they may be important. The purpose of the present investigation is to study by means of accurate 3D finite element (FE) models a coupled fracture mode generated by anti-plane loading of a straight through-the-thickness crack in linear elastic plates. An extended version of the present work has recently been published in the literature. The results obtained from the highly accurate finite element analyses have improved understanding of the behaviour of through cracked components under anti-plane loading. The influence of plate bending is increasingly important as the thickness decreases. It appears that a new field parameter, probably a singularity, is needed to describe the stresses at the free surfaces. Discussion on whether KIII tends to zero or infinity as a corner point is approached is futile because KIII is meaningless at a corner point. The intensity of the local stress and strain state through the thickness of the cracked components has been evaluated by using the strain energy density (SED) averaged over a control volume embracing the crack tip. The SED has been considered as a parameter able to control fracture in some previous contributions and can easily take into account also coupled three-dimensional effects. Calculation of the SED shows that the position of the maximum SED is independent of plate thickness. Both for thin plates and for thick ones the maximum SED is close to the lateral surface, where the maximum intensity of the coupled mode II takes place. K EYWORDS . Fracture mechanics; Finite element analysis; Anti-plane loading; Stress intensity factor; Corner point effects. Citation: Berto, F., Cracked components under anti-plane loading: recent outcomes and future developments, Frattura ed Integrità Strutturale, 41 (2017) 475-483. Received: 15.05.2017 Accepted: 26.07.2017 Published: 01.07.2017 Copyright: © 2017 This is an open access article under the terms of the CC-BY 4.0, which permits unrestricted use, distribution, and reproduction in any medium, provided the original author and source are credited.