Issue 33

F. Iacoviello et alii, Frattura ed Integrità Strutturale, 33 (2015) 111-119; DOI: 10.3221/IGF-ESIS.33.15 112 a very high wear resistance and fatigue strength. Difference between DCIs and low carbon steels tensile properties are summarized in Fig. 1, considering the microstructure influence on UTS and elongation [4]. Figure 1 : UTS-Elongation for different DCI and low carbon alloys [4]. Focusing on the fatigue crack propagation resistance, microstructure influence is more evident corresponding to higher values of the stress ratio and the applied stress intensity values [5], Fig. 2, where ferritic-pearlitic DCI (50% F – 50% P) shows a fatigue crack propagation resistance that is analogous to the investigated ADI. Cavallini et alii [5, 6] proposed that this behaviour is due to an enhanced crack closure effect, due to the graphite nodule presence and to the different phases distribution and mechanical properties. Considering that pearlite (or bainite, in ADI) is characterized by a reduced ductility and higher UTS (Ultimate tensile strength) values, if compared to ferrite, this second peculiar crack damaging mechanism can be described as follows (Fig. 3):  corresponding to K max values, ferritic shields are more deformed than pearlitic (or bainitic in ADI) matrix (considering an equivalent stress level);  corresponding to K min values, pearlitic (or bainitic in ADI) matrix induces on ferritic shields a residual compression stress condition with a consequent enhancing of the closure effect. 10 10 -10 10 -9 10 -8 10 -7 10 -6 R = 0.1 100% F 50% F + 50% P 5% F + 95% P ADI R = 0.5 100% F 50% F + 50% P 5% F + 95% P ADI R = 0.75 100% F 50% F + 50% P 5% F + 95% P ADI da/dN [m/cycle]  K [MPa m 1/2 ] 3 50 Figure 2 : Microstructure and stress ratio influence on fatigue crack propagation in DCIs [5]. Figure 3 : Ductile and fragile graphite elements debonding influence on crack closure effect in ductile irons [5]. In this work, fatigue crack tip damaging micromechanisms in a ferritic-pearlitic DCI were investigated by means of scanning electron microscope (SEM) observations of the lateral surface of metallographically prepared Compact Type (CT) specimens, focusing both the role played by the graphite nodules and the influence of the phases distribution.