Issue 29

L. Petrini et alii, Frattura ed Integrità Strutturale, 29 (2014) 364-375; DOI: 10.3221/IGF-ESIS.29.32 364 Focussed on: Computational Mechanics and Mechanics of Materials in Italy Development of biodegradable magnesium alloy stents with coating Lorenza Petrini Civil and Environmental Engineering Department, Politecnico di Milano, Italy) lorenza.petrini@polimi.it Wei Wu, Dario Gastaldi, Lina Altomare, Silvia Farè, Francesco Migliavacca Chemistry, Materials and Chemical Engineering ‘Giulio Natta’ Department, Politecnico di Milano, Italy wei.wu@polimi.it , dario.gastaldi@polimi.it, lina.altomare@polimi.it, silvia.fare@polimi.it, francesco.migliavacca@polimi.it Ali Gökhan Demir, Barbara Previtali, Maurizio Vedani Department of Mechanical Engineering, Politecnico di Milano, Italy aligokhan.demir@polimi.it , barbara.previtali@polimi.it , maurizio.vedani@polimi.it A BSTRACT . Biodegradable stents are attracting the attention of many researchers in biomedical and materials research fields since they can absolve their specific function for the expected period of time and then gradually disappear. This feature allows avoiding the risk of long-term complications such as restenosis or mechanical instability of the device when the vessel grows in size in pediatric patients. Up to now biodegradable stents made of polymers or magnesium alloys have been proposed. However, both the solutions have limitations. The polymers have low mechanical properties, which lead to devices that cannot withstand the natural contraction of the blood vessel: the restenosis appears just after the implant, and can be ascribed to the compliance of the stent. The magnesium alloys have much higher mechanical properties, but they dissolve too fast in the human body. In this work we present some results of an ongoing study aiming to the development of biodegradable stents made of a magnesium alloy that is coated with a polymer having a high corrosion resistance. The mechanical action on the blood vessel is given by the magnesium stent for the desired period, being the stent protected against fast corrosion by the coating. The coating will dissolve in a longer term, thus delaying the exposition of the magnesium stent to the corrosive environment. We dealt with the problem exploiting the potentialities of a combined approach of experimental and computational methods (both standard and ad-hoc developed) for designing magnesium alloy, coating and scaffold geometry from different points of views. Our study required the following steps: i) selection of a Mg alloy suitable for stent production, having sufficient strength and elongation capability; ii) computational optimization of the stent geometry to minimize stress and strain after stent deployment, improve scaffolding ability and corrosion resistance; iii) development of a numerical model for studying stent degradation to support the selection of the best geometry; iv) optimization of the alloy microstructure and production of Mg alloy tubes for stent manufacturing; v) set up, in terms of laser cut and surface finishing, of the procedure to manufacture magnesium stents; vi) selection of a coating able to assure enough corrosion resistance and computational evaluation of the coating adhesion. In the paper the multi-disciplinary approach used to go through the steps above is summarized. The obtained results suggest that developed methodology is effective at designing innovative biomedical devices.