Issue 24

H. S. Patil et alii, Frattura ed Integrità Strutturale, 24 (2013) 151-160 ; DOI: 10.3221/IGF-ESIS.24.16 152 welding tool. The process was developed initially for aluminium alloys, but since then FSW was found suitable for joining a large number of materials. In FSW a non-consumable rotating tool with a specially designed pin and shoulder is inserted into the abutting edges of sheets or plates to be joined and traversed along the line of joint. The tool serves two primary functions: (a) heating of work piece, and (b) movement of material to produce the joint. The heating is accomplished by friction between the tool and the work piece and plastic deformation of work piece. The localized heating softens the material around the pin and combination of tool rotation and translation leads to movement of material from the front of the pin to the back of the pin. As a result of this process a joint is produced in ‘solid state’. During FSW process, the material undergoes intense plastic deformation at elevated temperature, resulting in generation of fine and equiaxed recrystallized grains. The fine microstructure in friction stir welds produces good mechanical properties. Fig. 1 shows a schematic diagram of the FSW process. Figure 1 : Schematic diagram of the FSW process. Many papers are present in the literature regarding this field. Further to joints of similar alloys, FSW is being studied for welding dissimilar alloys which can be of particular interest in some industrial applications. Some works can be found in the literature [3–7], but data is still scarce on the characterisation of 6082-6061 joint type. Some authors have demonstrated that the microstructure of the weld nugget of strongly different aluminium alloys is mainly fixed at the retreating side of the material [3]. Murr et al. [8] showed the properties of dissimilar casting alloys by FSW. The micro- structural evolution of dissimilar welds as a function of processing parameters has been widely studied in [9], showing the behaviour of AA6061–AA2024 materials. Dickerson et al. [10] found that friction-stir-welded butt joints are generally defect free if welding process conditions (welding speed and sheet thickness) are properly tuned within a ‘tolerance box’ for a particular alloy. It is not possible to assume that FSW will be free of flaws, however, because manufacturers may want to run FSW outside the tolerance box in order to increase productivity. The weld zones are more susceptible to corrosion than the parent metal [11-16]. Generally, it has been found that Friction stir (FS) welds of aluminium alloys such as 2219, 2195, 2024, 7075 and 6013 did not exhibit enhanced corrosion of the weld zones. FSW of aluminium alloys exhibit intergranular corrosion mainly located along the nugget’s heat-affected zone (HAZ) and enhanced by the coarsening of the grain boundary precipitates. Coarse precipitates and wide precipitate-free zones promoted by the thermal excursion during the welding are correlated with the intergranular corrosion. The effect of FSW parameters on corrosion behaviour of friction stir welded joints was reported by many workers [14, 16]. The effect of processing parameters such as rotation speed and traverse speed on corrosion behaviour of friction stir processed high strength precipitation hardenable AA2219-T87 alloy was investigated by Surekha et al. [16]. However, researchers have nevertheless been strained to study competent study of the mechanical properties in terms of UTS, YS and % elongation, microhardness test, fractography analysis, metallurgical properties, and corrosion behaviour and the main causes of developing defects with changing FSW parameters for a dissimilar aluminium joint of AA6082 with AA6061. Selection of process parameters is an important issue in the FSW process, particularly in the case of joining dissimilar alloys. In the present paper, the effect of different welding speeds on the weld characteristics of advancing and retreating side of AA6082-T6 and AA6061-T6 fabricated by a hexagonal tool pin profile is investigated.