Table of Contents - ICMFF9

ICMFF9

• Multiaxial Fatigue Modeling and Some Simple Approximations
• Scale Levels of Crack Closure Effects and Simulation of Fatigue Cracking of Al-based Sheet Materials Subjected to Biaxial Cyclic Loads
• Material Influence on Multiaxial Fatigue Response
• Notch Effect on Multiaxial Low Cycle Fatigue
• Current Trends in Multiaxial Fatigue Research and Assessment
• Fatigue life of specimens with round and rectangular cross-sections under out-of-phase bending and torsional loading
• A general multiaxial method to estimate the local elastic-plastic behavior from a purely elastic solution
• A new solution for 3D crack extension based on linear elastic stress fields
• Fatigue crack growth analysis of structural components – the UniGrow two-parameter driving force model
• Estimating the notch and mean stress effect in fatigue through the degree of multiaxiality of the local elasto-plastic stress/strain fields
• Multiaxial fatigue strength assessment of components treated by surface induction hardening
• Material dependence of multiaxial low cycle fatigue damage under non-proportional loading
• IDD (Integration of Damage Differentials): general representation
• Fatigue damage accumulation in a structural steel (42CrMo4) subjected to axial/torsional bi-axial loadings
• A strain energy based criterion for multiaxial fatigue failure
• A new test method for obtaining stable mode III crack growth under RCF condition
• A brief introduction to coiled springs as a power source
• Interface and bulk fracture modes and strengths determined by laser-induced stress pulses
• Methodology for lifing turbine disk bores under multiaxial states of stress
• On the generation of a loading history with zero mean for structures subjected to multiaxial variable stresses
• Fatigue behaviour of laserbeam welded thin steel and aluminium sheets under multiaxial loading
• Experimental investigation of stress-strain curves in a cast TRIP steel under biaxial planar loading
• A multiaxial fatigue approach to estimate crack initiation and stress gradient effect in fretting
• 3D shear-mode fatigue crack growth in maraging steel
• Fatigue crack propagation under torsional spectrum load of a helicopter tail rotor shaft after ballistic damage
• Damage nucleation in nuclear graphite under biaxial flexural loading
• Life estimation of a composite structural component in a multi-axial stress state
• Multiaxial fatigue criteria applied to medium speed diesel engines
• Phenomenological lifetime assessment for turbine housings of turbochargers
• A study on notch fatigue based on multiaxial gradient dependent fatigue limit criterion
• The influence of static normal stress on shear capacity of bonded high strength steel interfaces
• Notch effect on torsional fatigue of austenitic stainless steel
• Multiaxial deformation and fatigue behaviors under descriminating strain paths
• Inelastic analysis of power plant components under transient thermal environment
• Multiaxial fatigue life assessment of components of forged steel Ck 45 (SAE 1045) and of sintered steel Fe-1.5Cu by integration of damage differentials (IDD)
• Fatigue life assessment of laserbeam welded steel tube-tube joints under constant amplitude out-of-phase combined axial loading and torsion by integration of damage differentials (IDD)
• Rotating bending with constant torsion and rotated bending with constant or variable torsion
• Notch optimization under multiaxial loading
• An extrapolation method applied to a constitutive material model to recalculate creep fatigue experiments
• Biaxial fatigue of aluminum alloy 1100
• Mean strain effect on multiaxial fatigue behavior of Ti-6Al-4V under non-proportional loading
• Strength degradation analysis of notched concrete beam based on numerical simulation of bending test under sequential loads
• Fatigue lifetime assessment of notched components under multiaxial variable amplitude loading based on a short crack growth concept
• In-plane and out-of-plane crack-tip constraint effects under biaxial loading in plastic and creeping materials
• Effects of biaxial loading on inclined surface cracks behavior
• Multiaxial study of notched component of Sn-3.5Ag solder in creep-fatigue
• BEM simulation and experimental test of a FML full scale aeronautic panel undergoing biaxial static and fatigue load
• Loading phase angle effect on Multiaxial behaviour of 30CrNiMo8HH
• Mean stress effect during cyclic stress/straining of 42CrMo4 structural steel
• Improvements in the algorithms for the determination of the shear stress components in critical plane class fatigue criteria
• On the formulation of non-local multiaxial high-cycle fatigue models based on the theory of critical distances
• An energy-based fatigue model for wrought magnesium alloy under multiaxial load
• Effect of non-proportional multiaxial fatigue loading on micro crack initiation and propagation of Ti-6Al-4V
• A study of biaxial fatigue behavior of a synthetic rubber
• A comparison of fatigue characteristics of structural steels measured by means of classical and miniature test samples
• Effect of interference of crack faces on shear-mode threshold for small fatigue cracks in a bearing steel
• Is Miner’s law valid for asphalt mixes?
• The effect of mean stress on tension-torsion high-cycle fatigue failure of 2A12-T4 aluminum alloy
• Low-cycle fatigue behaviour and microstructure development of copper and alpha-brass under planar biaxial loading
• Fatigue crack growth analysis under mixed mode loading
• Fracture of aluminium alloy 2024 under triaxial loading
• Multiaxial fatigue damage modeling of TiAl4V alloy
• An alternative measure for the shear stress amplitude in critical plane based multiaxial fatigue models
• On determination of bifurcation angle in V-notched Brazilian disc specimen under mixed mode loading
• Low cycle lifetime assessment of Al2024 alloy
• Life estimation in specimens with stress gradient: notches and fretting fatigue
• Benefit of taking account of the yield-point phenomenon in a multiaxial constitutive model of cyclic plasticity
• History effects in fatigue under variable amplitude laoding mode I conditions in a 316L stainless steel
• The influence of combined loading on fatigue crack growth from small defects
• Numerical modelling of fatigue damage in gears tooth root
• Cohesive zone model for the simulation of fatigue crack growth in adhesive joints under mixed mode I/II loading conditions
• Multiaxial fatigue assessment for notched bar under non-proportional loading using integral stress approach
• Strain-life behavior of different groups of metallic materials
• System for automated fatigue crack growth testing under biaxial loading
• Fatigue crack growth under flight spectrum loading with superposed fuselage cabin pressure
• Study and 3D analysis of the drilling process influence on notched single crystal superalloy specimens
• Multiaxial fatigue assessment for notched bars under non-proportional loading using integral stress approach
• Investigation of multiaxial fatigue in the prospect of turbine disc applications: Part I – Experimental setups and results
• Investigation of multiaxial fatigue in the prospect of turbine disc applications: Part II – Fatigue criteria analysis and formulation of a new combined one
• Multiaxial fracture model for weak fiber\matrix interface composite within the three bending fatigue test
• Specimen for fracture characterization of material under biaxial stress fields
• Three-dimensional analysis of dissipated energy in fatigue crack growth
• A biaxial endurance criterion developed within the linear elastic fracture mechanic frameworks
• A study of the stability of sharp notches in the orthotropic heterogeneous media
• Assessment of critical defects in a PSA pressure vessel subjected to cyclical loading using BS-7910 procedures
• 3D model for the evaluation of multiaxial fracture behavior of reinforced concrete members
• Investigation on the shrink-fitted assemblies with a circumferential groove
• A strategy for the estimation of the fatigue life of notched components under random multiaxial fatigue
• A model for biaxial fatigue limits
• Cyclic calculations and life estimation in thermomechanical fatigue
• Fatigue strength of welded joints under multiaxial loading in terms of local strain energy density
• Multiaxial HCF and LCF constraints in topology optimization
• Mixed mode deformation in a cracked asphalt pavement subjected to traffic loading
• Multiaxial fatigue behavior of short-fiber reinforced thermoplastic roof bars
• Fatigue assessment of crane rail welds by local concepts
• Multiaxial fatigue resistance in thermoplastics and correlation to cyclic behavior
• Analytical and numerical modelling of the Swift effect in elastoplastic torsion
• On the use of the Modified Wöhler Curve Method applied along with the Reference Radius Concept to perform the multiaxial fatigue assessment of welded joints
• A damage mechanics approach to multiaxial fatigue
• Fatigue assessment of smooth metallic specimens using a simplified multiaxial criterion based on the critical plane approach
• Fatigue damage on steel space truss systems